1. NAME▲

enum_mac80211_rx_flags - receive flags

2. SYNOPSIS ▲



 
Sélectionnez
enum mac80211_rx_flags {
  RX_FLAG_MMIC_ERROR,
  RX_FLAG_DECRYPTED,
  RX_FLAG_MMIC_STRIPPED,
  RX_FLAG_IV_STRIPPED,
  RX_FLAG_FAILED_FCS_CRC,
  RX_FLAG_FAILED_PLCP_CRC,
  RX_FLAG_MACTIME_START,
  RX_FLAG_SHORTPRE,
  RX_FLAG_HT,
  RX_FLAG_40MHZ,
  RX_FLAG_SHORT_GI,
  RX_FLAG_NO_SIGNAL_VAL,
  RX_FLAG_HT_GF,
  RX_FLAG_AMPDU_DETAILS,
  RX_FLAG_AMPDU_REPORT_ZEROLEN,
  RX_FLAG_AMPDU_IS_ZEROLEN,
  RX_FLAG_AMPDU_LAST_KNOWN,
  RX_FLAG_AMPDU_IS_LAST,
  RX_FLAG_AMPDU_DELIM_CRC_ERROR,
  RX_FLAG_AMPDU_DELIM_CRC_KNOWN,
  RX_FLAG_MACTIME_END,
  RX_FLAG_VHT,
  RX_FLAG_80MHZ,
  RX_FLAG_80P80MHZ,
  RX_FLAG_160MHZ
};

3. CONSTANTS ▲

RX_FLAG_MMIC_ERROR
    Michael MIC error was reported on this frame. Use together with RX_FLAG_MMIC_STRIPPED.

RX_FLAG_DECRYPTED
    This frame was decrypted in hardware.

RX_FLAG_MMIC_STRIPPED
    the Michael MIC is stripped off this frame, verification has been done by the hardware.

RX_FLAG_IV_STRIPPED
    The IV/ICV are stripped from this frame. If this flag is set, the stack cannot do any replay detection hence the driver or hardware will have to do that.

RX_FLAG_FAILED_FCS_CRC
    Set this flag if the FCS check failed on the frame.

RX_FLAG_FAILED_PLCP_CRC
    Set this flag if the PCLP check failed on the frame.

RX_FLAG_MACTIME_START
    The timestamp passed in the RX status (mactime field) is valid and contains the time the first symbol of the MPDU was received. This is useful in monitor mode and for proper IBSS merging.

RX_FLAG_SHORTPRE
    Short preamble was used for this frame

RX_FLAG_HT
    HT MCS was used and rate_idx is MCS index

RX_FLAG_40MHZ
    HT40 (40 MHz) was used

RX_FLAG_SHORT_GI
    Short guard interval was used

RX_FLAG_NO_SIGNAL_VAL
    The signal strength value is not present. Valid only for data frames (mainly A-MPDU)

RX_FLAG_HT_GF
    This frame was received in a HT-greenfield transmission, if the driver fills this value it should add IEEE80211_RADIOTAP_MCS_HAVE_FMT to hw.radiotap_mcs_details to advertise that fact

RX_FLAG_AMPDU_DETAILS
    A-MPDU details are known, in particular the reference number (ampdu_reference) must be populated and be a distinct number for each A-MPDU

RX_FLAG_AMPDU_REPORT_ZEROLEN
    driver reports 0-length subframes

RX_FLAG_AMPDU_IS_ZEROLEN
    This is a zero-length subframe, for monitoring purposes only

RX_FLAG_AMPDU_LAST_KNOWN
    last subframe is known, should be set on all subframes of a single A-MPDU

RX_FLAG_AMPDU_IS_LAST
    this subframe is the last subframe of the A-MPDU

RX_FLAG_AMPDU_DELIM_CRC_ERROR
    A delimiter CRC error has been detected on this subframe

RX_FLAG_AMPDU_DELIM_CRC_KNOWN
    The delimiter CRC field is known (the CRC is stored in the ampdu_delimiter_crc field)

RX_FLAG_MACTIME_END
    The timestamp passed in the RX status (mactime field) is valid and contains the time the last symbol of the MPDU (including FCS) was received.

RX_FLAG_VHT
    VHT MCS was used and rate_index is MCS index

RX_FLAG_80MHZ
    80 MHz was used

RX_FLAG_80P80MHZ
    80+80 MHz was used

RX_FLAG_160MHZ
    160 MHz was used

4. DESCRIPTION ▲

These flags are used with the flag member of struct ieee80211_rx_status.

5. AUTHOR ▲

Johannes Berg <>
    Author.

6. COPYRIGHT ▲